收藏本站
MRF89XA
3.3
Transmitter
3.3.4
f dev SETTING IN OOK MODE
The MRF89XA is set to Transmit mode when the
CMOD<2:0> bits (GCONREG<7:5>) are set to ‘ 100 ’
(see Register 2-1 ).
The transmitter chain in the MRF89XA is based on the
same double-conversion architecture and uses the
same intermediate frequencies as the receiver chain.
3.3.1 BIT RATE SETTING
In Continuous Transmit mode, setting the bit rate
through the BRVAL<6:0> bits (BRSREG<6:0>) is
useful to determine the frequency of DCLK. As
explained in Section 3.9.1, TX Processing , DCLK will
trigger an interrupt on the host microcontroller each
time a new bit has to be transmitted, as shown in
f dev has no physical meaning in OOK Transmit mode.
However, due to the DDS baseband signal generation,
the OOK signal is always offset by “- f dev ” (see
Section 3.2.7, Frequency Calculation). It is suggested
that f dev retains its default value of 100 kHz in OOK
mode.
3.3.5 INTERPOLATION FILTER
After digital-to-analog conversion, the I and Q signals
are smoothened by interpolation filters. Low-pass filters
in this block digitally generates the signal and prevent
the alias signals from entering the modulators. Its
bandwidth can be programmed with the
(TXIPOLFV<6:0> bits (TXPARCREG>7:1), and should
be calculated as shown in Equation 3-7 .
Equation 3-4 .
EQUATION 3-7:
f xtal
64 ? [ 1 + val ( BRVAL<6:0> ) ]
BW ? 3 ? f dev + -------
EQUATION 3-4:
BR = ----------------------------------------------------------------------
BR
2
Where,
f dev is the programmed frequency deviation
as set in FDEVREG
3.3.2
ALTERNATIVE SETTINGS
BR is the physical bit rate of transmission
Bit rate, frequency deviation, and TX interpolation filter
settings are a function of the crystal frequency ( f xtal ) of
the reference oscillator. Settings other than those
programmed with a 12.8 MHz crystal can be obtained
by selecting the correct reference oscillator frequency.
Note:
Low interpolation filter bandwidth will
attenuate the baseband I/Q signals, thus
reducing the power of the FSK signal.
Conversely, excessive bandwidth will
degrade spectral purity.
3.3.3
f dev SETTING IN FSK MODE
For most of the applications a BW of around 125 KHz
? [ 1 + val ( FDVAL<7:0> ) ]
f dev = ------------------------------------------------------------------------
2 ? f dev
The frequency deviation, f dev , of the FSK transmitter is
programmed through the FDVAL<7:0> bits
(FDEVREG<7:0>), as shown in Equation 3-5 .
EQUATION 3-5:
f xtal
32
For correct operation, the modulation index β should
be equal to Equation 3-6 .
EQUATION 3-6:
β = ------------------- ≥ 2
BRVAL
For communication between a pair of MRF89XAs the
f dev should be at least 33 kHz to ensure a correct
operation on the receiver side.
would be acceptable, but for wideband FSK
modulation, the recommended filter setting cannot be
reached. However, the impact on spectral purity will be
negligible due to the existing wideband channel.
? 2010–2011 Microchip Technology Inc.
Preliminary
DS70622C-page 59
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
MRF89XAM9A-I/RM IC TXRX MOD 915MHZ ULP SUB-GHZ
MRX-001-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-002-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-002SL-433DR-B MODULE RCVR 433MHZ SAW LN 24DIP
MRX-005-915DR-B MODULE RECEIVER 915MHZ 18DIP
MRX-005SL-915DR-B MODULE RCVR 915MHZ SAW LN 24DIP
MRX-007-433DR-B MODULE RECEIVER 433MHZ 18DIP
MRX-008-433DR-B MODULE RECEIVER 433MHZ 18DIP
相关代理商/技术参数
MRF89XAM8A-I 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Ultra Low-Power, Integrated ISM Band Sub-GHz Transceiver
MRF89XAM8A-I/RM 功能描述:射频模块 868MHz Sub-GHz transceiver module RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
MRF89XAM8A-I/RM 制造商:Microchip Technology Inc 功能描述:, Leaded Process Compatible:Yes, Peak Re
MRF89XAM9A_12 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:915 MHz Ultra Low-Power Sub-GHz Transceiver Module
MRF89XAM9A-I/RM 功能描述:射频模块 915MHz Sub-GHz Transceiver Mod RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
MRF89XAM9AT-I/RM 制造商:Microchip Technology Inc 功能描述:915 MHz Ultra Low-Power Sub-GHz Transceiver Module
MRF89XAT-I/MQ 功能描述:射频收发器 868/915/950 MHz Sub-GHz transceiver RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
MRF8HP21080HR3 功能描述:射频MOSFET电源晶体管 HV8 2.1GHZ 160W NI780H-4 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray